Missouri Wind and Solar 100 Amp Solid state Charge Controller with Digital LED Volt Meter for Solar Panels. Don't boil your batteries. Our charge controllers are designed to more slowly top-off your battery. It will do this by adjusting itself every time your battery is full by increasing the duration of the next OFF cycle by up to 4 increased OFF times.
Benefits of Solid State Relay. No contact bounce or arcing. Lower shock and vibration sensitivity.No magnetic field or electrical noise generation. Dual microprocessor controlled for stability and accuracy. Multiple user changeable settings and trip points for many various system requirements and applications. Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board.
Battery Status LED lets you know your battery's actual voltage! Plug & Play: Long leads for easy termination to your 12 volt battery or battery bank. Ultra low power consumption, even with the voltmeter on (almost negligible). The voltmeter can be set to turn off after periods of inactivity. Designed, assembled and quality checked in Missouri USA using global parts.
Be aware of cheap, less capable knock-offs of our model controller that are too basic to properly charge a battery. They will attempt to only turn ON and OFF for the SAME length of time, every time, when your battery is full.This will constantly boil your battery when it's full or not properly fill it or both. An improperly charged battery will have a short life and cannot be brought back. One to two years instead of 10 years or more life! A charge controller must operate a relay whether mechanical or solid state (SSRs).
The relay turns the charging from your solar, wind, hydro ON or OFF to your batteries. If you have 100 amps of solar charging being turned ON and OFF to your batteries, you NEED to vary the time between the ON/OFF cycles. Our controller has custom programming that cannot be duplicated by hobbyist sellers.For example: 5 seconds to 10, then 10 to 20, then 20 to 40 and will maintain a 40 second OFF time. You can adjust the starting 5 seconds down to 1 or up to 999. We even went a step further and programmed in a "sweep time" which is a secondary sensing timer that starts directly following an ON cycle. This tells the controller that it has or has not been too long before battery charging is needed again. The user adjustable sweep time allows the user and controller to have a wide range of charging times on any size battery bank.
We also pre-wire and pre-program our controllers for you to be able to get up and going without having to become an expert. You're taking a risk with your system if accepting a too-good-to-be-true price or product description. If you're not convinced this is the controller for you, please check our other charge controllers or ask us which one is right for you. The item "100 Amp Solid State Charge Controller with LED Volt Meter for Solar Panels" is in sale since Sunday, October 13, 2019. This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Solar Power Supplies\Solar Charge Controller".The seller is "missouriwind" and is located in Seymour, Missouri. This item can be shipped worldwide.